Automatic washing machine at home in the process of using the event followed them inside the barrel, one-way forward / reverse different sound, washing dehydration no action and a series of problems, mostly because the clutch out of trouble, if you know of some Wenxiu knowledge, this problem will be solved. Here is a summary of some small series of common faults and maintenance and replacement, if you do not understand professional service, it is still ask professionals to repair it.
■ fault: washing bucket inside with turn
a: washing the barrels with clockwise rotation
Cause Analysis: ① lever coupling plate collide with traction, braking zone is not completely hold of brakes. ② clutch operation after a certain period, with badly worn brakes, friction is reduced. ③ there is oil on the brakes.
Repair method: ① connecting plate and lever position adjustment. ② ③ analysis should replace the brake with oil source, if the brakes itself is dirty, replace the brake disc brakes and clean. If the shaft assembly leakage, indicating the brakes and clutch shaft riveted joints cracked or damaged, you need to replace the clutch.
b: washing the barrels with counterclockwise rotation Cause Analysis: ① way tie between the bearing and the shaft dewatering loose, slipping phenomenon, with loose-way between the bearing and the housing ②, slipping phenomenon, ③ bad way bearing.
Repair: Replace the clutch.
■ Problem two: Washing Washing way forward / reverse different sound
Cause Analysis: ① When washing, ratchet assembly is not open certain margin, so that can not hold clutch spring rotate freely within the ratchet. ② ratchet bore contraction. ③ slip-way bearing in the housing.
Maintenance: Check the fork assembly in washing initial state deformation, deformation Ruoyi replacement fork assembly; if there is no deformation, compared with ratchet bore contraction, replacement ratchet assembly. If for reasons ③, when washing will be accompanied with the transfer of the phenomenon.
■ Problem three: No action dehydration
Analysis: ① lever and pull the gap between the coupling plate is too large not completely out of the ratchet pawl. ② fork adjustment screw and lever assembly gap is too large, leading to brake with the fork assembly does not fully open. ③ ④ ratchet hold spring break other reasons lead to bearing damage due to leaks, rust and brake disc brakes with bite.
Repair method: ① adjustment lever and the connecting plate to the proper position. ② adjustment lever adjusting screw and the gap between 0 ~ 0.2mm. ③ replacement ratchet hold spring assembly. ④ replace the clutch.
■ Failure four: wash no action
Cause Analysis: ① Rotate the pulley, if not rotate, it is a planetary gear stuck internal corrosion, or oil between the copper lining and shaft rust stuck. ② clutch can operate normally, check the impeller wear inserts. ③ belt wear fracture |
